Do-It-Yourself Laptop LCD Repairs

Laptop LCD repairs usually entail a replacement of the LCD. One option is to look for a broken laptop to serve as a donor for the LCD. Or you can buy a new one from your laptop’s manufacturer.

If you are bold enough,Do-It-Yourself Laptop LCD Repairs Articles you can take the whole matter of laptop LCD repairs into your own hands. You can ask the manufacturer of the LCD to give you a manual that has instructions on LCD replacements. With this helpful tool, you should be ready to do your own laptop LCD repairs. Read on for some helpful instructions.

The first step replacing an LCD is to remove the power cable and the battery. Next in line are the rubber grommets around the bezel. Make sure that you are using the right size of bit when working on the removals.

After you’re done removing the grommets, work on the bezel itself. Be extra cautious though. These bezels easily break as they are made of thin plastics. Also, bezels have a property that allows for an easy snap. This basically means a difficult job on unsnapping.

After a successful bezel removal, turn your attention to the metal frame at the laptop’s top lid. You will have to remove 14 screws before you can release the metal frame. After this step, you now work on the LCD. You have to lower the LCD panel into a resting position after which you remove 4 screws. This should release the LCD from the frame. Finally, unplug the wire connections ands remove the LCD panel.

It’s time to install your new LCD panel. Again, be very careful especially when handling your LCD panel. You didn’t buy a new one only to damage it. For a better protection, make it a point to lay down the panel on a soft surface. You can use a towel as buffer. Attaching the replacement LCD is actually doing the whole process of laptop LCD repairs I just mentioned above.

If I may reiterate, in laptop LCD repairs first thing to do is to reattach the four screws you removed from the old LCD panel after which you reattach the metal frame. You then lift the lid over the frame, just where you unattached it. You then reattach the 14 screws. Finally, you snap the delicate bezel back. This should be easier than the painstaking unsnapping process. Don’t forget to replace the rubber grommets and of course the bezel screws.

Now test try your laptop and celebrate all the benefits of doing laptop LCD repairs yourself. You get to save a lot of money and frustrations from dealing with sometimes impertinent technicians. And of course there is the prized benefit in the form of a sense of accomplishment.

Be careful not to turn the whole thing into a false economy. Be very careful in handling the delicate parts and be very meticulous with the instructions. You don’t want to turn a simple problem of LCD defect into a laptop overhaul. Remember that you intend to save money, not waste some. 3/8 in to mm


Posted

in

by

Tags:

Comments

Leave a Reply

Your email address will not be published. Required fields are marked *